Installation - Sinmag Europe Divo Handbuch

12. For all extraordinary maintenance, consult the manufacturer or qualified and au-
thorised personnel.
13. Do not use water jets or spray to clean the machine.
14.
When sharp accessories are manipulated, use cut-resistant gloves.
15. Never insert hands or other objects into the product inlet or outlet.

3. INSTALLATION

3.1 General installation requirements
NOTE:
It is most important that this machine is installed correctly and that the
operation is correct before use. Installation shall comply with local electrical,
fire, health and safety requirements.
This machine is designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
3.2 Installation
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install
equipment to relevant codes and manufacturers specifications in this section will void
the warranty.
Components having adjustments protected (e.g. paint sealed) by manufacturer are
only to be adjusted by an authorised service agent. They are not to be adjusted by the
installation person.
It is the responsibility of the owner to supply and arrange for the connection of all ser-
vices to the machine.
3.3 Unpacking
On receipt of the machine, carry out the following: Remove all packaging and transit
protection including all protective plastic coverings from outer panels.
Check equipment and parts for damage. Report any damage immediately to the carrier
and distributor. Never attempt to operate the machine with damaged parts.
Report any deficiencies to the distributor who supplied the machine.
3.4 Location
1.
Select a location for the machine with a minimum of 0.6m space around the ma-
chine for operating, cleaning and servicing.
2.
Position the machine in its approximate working position. the machine must be
installed on a flat, solid and dry floor.
3.
It is recommended that the machine is level from front to back and from side to side.
This will ensure the greatest stability.
SINMAG EUROPE BVBA
ENG
5