Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
No sound (but pictures are displayed)
Ensure that the players audio output has a good connection with monitors audio input.
Check whether the audio connector is damaged.
Check whether you have turned down the volume.
Ensure that you have set the right AUDIO setup of the player.
Ensure that the audio is not under mute.
No visual (but sound is played)
Ensure that the players video output has a good connection with monitors video input.
Check whether the video connector is damaged.
Ensure that you have set the right VIDEO settings of the player.
Black and white pictures and/or screen is rolling
Ensure that you have set the right video SYSTEM (e.g. PAL, NTSC) setting.
Flaws in visuals or sound
Check whether the setting of AUDIO is right.
Check whether the AV connector and the output terminal is stained.
Check whether there is condensation inside the Lens. If so, leave the player off for an hour or so, then try again.
RC is insensitive or does not work
Check the batteries of remote control and make sure that they are to be powerful and good conductivity.
Direct the remote control to the IR sensor of the player.
Check whether there are some obstacles between the remote control and IR sensor.
Some buttons do not work
Turn off the power, then turn on again.
Reset the unit to zero, then turn on again.
Remove the front panel from the unit, then install it again and then turn on again.
The radio does not work
Check whether the antenna cable is connected firmly. Or manually tune for a station.
The display lost its touch effect
In radio mode, press + button thrice and then press - button thrice and then press the power button to turn on
calibrate mode and then tap the cross cursor as it shows until it displays "Adjust Finish".
31
Werbung
Inhaltsverzeichnis
