User Interface; Important Note - Whirlpool PACW29COL Gebrauchsanweisung

User Interface

Start to use your air conditioner
1. Press the power button to start or stop the
operation of your appliance.
2. Press the mode button to select the
operation mode in sequence of Cool Dry,
Fan or Heat.
3. Press the temperature adjustment button to
set the desired temperature.
4. Press the FAN button to choose the desired
fan speed in sequence of High, Mid or Low.
Filter Reset
1. When the Filter Reset indicator light is lit,
remove, clean and replace the air filter. See
"Cleaning the Air Filter" .
2. Press and release FILTER button after
replacing the air filter.
NOTE: After 360 hours of fan operating time,
the Filter indicatorlight will turn on. It will
remain on for 180 hours or until you press
FILTER button.
After 180 hours, it will turn off automatically.

IMPORTANT NOTE:

* When the air conditioner is turned on for the first time
after it' s plugged in, it will run in the 6th Sense Mode.
* The air conditioner display shows the setting
temperature.
Only on standby mode, the display shows the ambient
temperature.
* When changing modes while the air conditioner is
operating, the compressor will stop for 3 to 5 minutes
before restarting.
If a button is pressed during this time, the compressor
will not restart for another 3 to 5 minutes.
* In Cooling or Dry mode, the compressor and
condenser fan will stop when the room temperature
reaches the set temperature
* In Fan Only mode, the temperature can NOT be set.
* Heating is NOT available for Cooling only air
conditioner.
* Below operation modes can only be set by remote
controller.
* In the event of a power failure, your air conditioner will
operate at the previous settings when the power is
restored.
* If the unit is operating in UNLIKELY VERY HUMIDITY
environment, water will be collected in the tank inside
the unit. The air conditioner will stop once the water
tank is full, and the screen will display "E5" to inform
you to empty the internal container. There is a plasic
tube at the back of the appliance, move the appliance
to a safe place, lay down the plastic tube for water
drain.
-13-