Starting And Stopping The Timer; Backlight; Key Lock; Useful Tips - Clas Ohlson TC-C1 Bedienungsanleitung

4.3 Starting and stopping the timer
The [ ] button controls the timer function.
1. Press [ ] to start the timer once it has been set.
2. Press [ ] again to stop the timer.
The timer settings are saved and will continue if the timer is started again.

4.4 Backlight

1. Press [ ] to switch the backlight on.
2. The light will automatically go out after about 6 seconds.

4.5 Key lock

Locks all the buttons except [
changes to settings. The accidental stopping of a started function using the [
button is prevented.
Note: The manual remote shutter release (3) is not affected by the key lock.
1. Hold in [ ] for at least 3 seconds until
2. Hold in [ ] for at least 3 seconds until
Note: Always check that the
trying to take a picture. If the symbol is displayed, the key
lock function must be deactivated. Then press [
the set function.

4.6 Useful tips

Remember to set the shooting mode to single-frame shooting, if the camera is set to
continuous shooting the camera will not be controlled by the remote shutter release
but by the camera settings.
When using the remote shutter release unattended:
• Focus your camera manually. In auto mode the camera automatically focuses
before an exposure, in this case the remote shutter release will not work.
• Do not use the camera timer at the same time as the remote shutter release, as
the remote shutter release will not function correctly.
• Press [ ] to stop the timer function before changing the memory card.
• The remote shutter release should be covered if used outdoors, it is not waterproof.
] and [ ] upwards/downwards to prevent accidental
is displayed to lock the buttons.
disappears to unlock the buttons again.
is NOT displayed before
] to start
8
]