6.2 Starting a long exposure
Press[
] to start a long exposure.
Press the button again to interupt the countdown before the exposure is complete.
"RELEASE" flashes on the display for as long as the shutter is open.
Note: If the camera is not in bulb mode, continuous exposures will be made during
the entire set "long exposure" time (or until the memory card is full).
7. Interval timer
First set the time interval between exposures (INTVL) and then set the exposure count (N).
7.1 Setting
Set the camera to single shoot mode.
1. Press [ ] the required number of times to select INTVL.
2. Set the interval time in the same way as you did in 4.1 Settings.
3. Press [ ] 1 time to advance to N (exposure count).
4. Press [ SET ] to enter the settings mode.
5. Press [ ] upwards/downwards repeatedly to set
the exposure count.
6. Press [ SET ] to confirm the set exposure count.
Note: If the flash is used, the interval time must be set to
a longer time than the flash recharge time.
7.2 Starting the interval timer
Press [
] to start the interval timer.
Press the button again to interupt the interval timer operation
before the exposure is complete.
"RELEASE" flashes on the display for as long as the shutter is open.
Note: The exposure count (N) can be set from 1 to 399, but it is
possible to select an unlimited number of exposures by setting
(N) to (- -) mode. In (- -) mode, the exposures will continue
until the memory card is full or the timer function is interupted
manually.
10