Installation; Preliminary Checks - Motostar S500R Installationsanleitung

INSTALLATION

Only skilled, qualifi ed staff must install this product.
If the door is fi tted with a pedestrian door, you must also fi t a safety switch at the entrance, to stop the operator from working
when the pedestrian door is open.

Preliminary checks

Before beginning the installation, do the following:
• make sure you have set up a suitable dual pole cut off device along the power supply that is compliant with the installation rules.
It should completely cut off the power supply according to category
III surcharge conditions (that is, with minimum contact openings of
3 mm);
• Setup suitable tubes and conduits for the electric cables to pass
through, making sure they are protected from any mechanical
damage;
• make sure that any connections inside the container (ones that
ensure continuity to the protection circuit) are fitted with additional
insulation with respect to those of other electrical parts inside:
• make sure that the door is properly balanced. When stopped at any
point, it must maintain its position.