Optional Functions - Motostar S500R Installationsanleitung

Adjusting the sensitivity
The door must be properly balanced. If the sensitivity is too low it could cause the door to malfunction.
By default, the sensitivity is set to a medium level. To increase or reduce sensitivity:
Press P for about five
1
seconds, 1 appears.
”
Press + o - to set
the suitable sensitivity
4
level.
 The last phase of programming must always be memorized (function 5).
Once memorization is complete, perform two opening and closing cycles to confirm that the settings have been saved.

Optional functions

Setting the alarm
By default, this function is deactivated; by activating the alarm function, the operator emits a long sound signal if the door stays open for more than
10 minutes. To activate it:
Press P for about five
1
seconds, 1 appears.
”
Press + and select
1. The alarm is now
4
activated.
 Memorizing (function 5) must always be the last phase of programming, otherwise the settings will not be saved.
Press + and select
2
4
.
5
Minimum level of Maximum sensitivity
Press + and select
2
6
Press P to save the
5
procedure.
Press P, appears .
3
Press P to save the
6
procedure.
Press P, 0 appears
3