simu AUTOSUN Bedienungsanleitung Seite 6

4.2 - Fixing the Panel
1
Reminder: Battery pack installation
5
1
1
2
1
1
2
Ø 3mm
Reminder: motor installation
6
29
Ø38,2
PLASTITE FXS N7\7X12 ZING
1,2
End limits adjustment
7
- During the operations in this section (§7), do not
work on several motors at the same time.
7.1
a- Connect the motor to the power supply.
b- Connect the solar panel to the battery pack.
2 / 4
2
18,7 mm Max.
- Recharge the battery before use with the charger ref.: 9014738. WARNING: Do not charge
at a temperature above 70°C.
18
- Charge duration: 3h30 max. 2 charges by year max.
- Never leave a battery in a discharged condition.
10
- No not open or pierce the battery.
- Do not put the battery into a fire, risk of explosion. Keep away (1m minimum) from from all types of
flames, sparks or incandescent material.
- Do not create a short circuit on the battery terminals: danger of burns and explosion.
- The battery must be replaced by a professional with an identical model.
- Do not put in the dustbin, this is a recyclable product.
- The battery must be sheltered from the rain (IP X4).
- The battery must be accessible in order to carry out possible recharging (see instruction sheet 5055192).
478,5
- For more information about installation of the battery depending on the type of case, see Technical
booklet ref: 5059076
2
A
ØB
C
D
L2
L1
1
- For more information about installation of the motor, see technical leaflet ref: 5055191.
battery 12V - 2.2Ah ref.: 9014734
1- Pass the wires of the Panel inside the box (Ø16 hole) with the
protective foam.
2- Fix the Panel using aluminium Ø4,8 pop rivets in the Ø5 holes dril-
led during operation 4.1.
- For more information about installation of the panel, see
technical leaflet ref: 5117585.
1
1
Connector for charger
2
A
ØB
Ø min.
(mm)
3Nm - 6Nm - 10Nm
37
4
9016635
=
40
Programming button
A ØB C D L1
(mm) (mm) (mm) (mm) (mm)
433 4,2 8 5,5 457
3
2
b
a
T3.5 DC EHz
L2
(mm)
470