wehncke Professional Betriebsanleitung Seite 8

again by means of the plug, subsequent to the
inflating procedure and after the adapter has been
removed. Subsequently, press the valve inwards
as far as possible into the air chamber.
Deflating the air chambers
Unscrew the valve cap A, push down the deflation
button D and turn the valve in clockwise direction
by 90° until it is locked. Release the valve and the
air can escape automatically. If you want to stop
deflation, push down the deflation button D and
turn it in counter-clockwise direction by 90°. When
the valve jumps up, the deflation stops.
For the deflating procedure of the floor chambers
and seat cushions, pull out the valve from the air
chamber and pull out the plug from the valve
neck. Press the valve neck by means of two fin-
gers in such a way that the air can escape. When
the complete evacuation of air from the air cham-
bers is intended, press the air chambers forceful-
ly in addition.
In case of leaking of valve caused by dust or dirt
adhering to valve seal proceed as follows:
1. Inflate boat body with ample air.
2. Press the deflation button of the valve, then
quickly release your finger and the air flow will
clear the valve.
3. Repeat several times.
Preparation for utilization
Install the inflated seats at the locations provided
for this purpose in the boat.
Oars
The two oars allow effective rowing of the boat
and are guided in the oar locks attached to the
boat. If the oars are not required, fix them to the
oar holders on each side of the boat.
Oar assembly
A: Oar retainer ring
B: Coupler
C: Rear shaft
D: Blade
Assemble the oars. Join them together by scre-
wing the coupler with front shaft and rear shaft.
Insert the front shaft into the oar locks from outsi-
de of the boat. Place the oar retainer ring on the
inside of oar locks to prevent the oar from sliding
into the water.
In the case of boats equipped with an engine,
hang the transom board provided for the fastening
of the engine with its fastening devices in the
fastening eyes located at the right and left hand
side at the stern.
Insert the enclosed motor reinforcement (plastic
board) into the pocket on the stern. The installati-
on of the engine must be effected in compliance
with the instructions of the engine manufacturer.
Close the draining valves before the boat is laun-
ched.
For launching the inflated boat, it is necessary to
carry the boat to the shore. Do not drag the boat
along the beach; otherwise the plastic sheet may
- 9 -
G
B