Hameg HM8123 Benutzerhandbuch Seite 27

ARMED
Activating/Deactivating of ARMED function, corresponds
to pushbutton ARMED 28
AR0 ARMED function off
AR1 ARMED function on
GATED
Activating/deactivating of GATED function, corresponds to
pushbutton GATED 30 .
GT0 GATED function off
GT1 GATED function on
OFFSET
Activating/deactivating of OFFSET function, corresponds
to pushbutton OFFSET
29
OF0 OFFSET function off
OF1 OFFSET function on
HOLD
Activating/deactivating of HOLD function, corresponds to
pushbutton HOLD .
27
DH0 Display hold off
DH1 Display hold on
Display
Activating/deactivating the display, corresponds to menu
item Display.
DS0 Display off
DS1 Display on
Miscellaneous parameters
NPCxxxx Setting of pulses per revolution for rpm
measurement (xxxx: 1 ..65,535)
TRG Trigger
RES Reset
STR Starting event counting
STP Stop of event counting
Requests of parameters:
These commands allow to request parameters and the ac-
tual results from the instrument.
VER Request for software version number of the
HM8123 (e.g. 1.00)
IDN Identification string (HAMEG HM8123)
FN? Measurement function (e.g. FRA)
SMT? Gate time in ms (e.g. 400ms)
LVA? Trigger level in V of channel A (e.g. +0.100)
LVB? Trigger level in V of channel B (e.g. -1.000)
XMT Request of results, format: value, unit
MA? Settings of channel A Example:
MB? Settings of channel B
Example: Z:50 CPL:AC FL:ON ATT:1 SLP+
Explanation: Z:50
CPL:AC = AC coupling
FL:ON
ATT:1
SLP+
.
.
= Input impedance 50 Ω
= Low pass filter on
= Attenuator off
= Positive slope
Remote control
27