All 0Ff" Function - Medion MD 4689 Anleitung

Univ-FB MD 4689 ML.book Seite 18 Mittwoch, 5. Juli 2006 9:46 09
• Use new batteries for both remote controls.
• Only one appliance code can be stocked per Mode key
• Point your existing remote at the MD4689 remote (front to front) with a
distance of about 5 centimetres between the remotes.
• You can stock up to 150 codes. When the memory capacity is full, the LED will
blink during 3 seconds.
• Learning a key can take 3 seconds
• Always check that the MD4689 key you wish to teach a code is free or does
not correspond to an important function.
• No functions may be stored under the following keys: LEARN, SET, ALL 0FF,
P<P, SHOWVIEW, and any other MODE key.
• Experiment by learning 1 code initially (to ensure compatibility) and then clear
the stored learned commands before completely learning your original
remote's keyboard.
SETTING PROCESS
1. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
2. Release the "SET" key.
3. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).The LED blinks.
4. Press "LEARN" key.
5. Press and release the button on the MD4689 remote which will learn the
function. (The LED permanently lights on).
6. Press the function key on your original remote that you want to transmit. Hold
the key until the LED on the MD4689 blinks once. (Any wrong setting is
indicated by a blinking of the LED)
7. Repeat steps 5 and 6 for each function you want to learn.
8. When you're finished learning all the keys, press "SET".
TO CLEAR ALL STORED LEARNED COMMANDS UNDER A MODE KEY
1. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
2. Release the "SET" key.
3. Press and release the mode key of the device you wish to control (TV, VCR,
DVD, CD, SAT, AUX).The LED blinks.
4. Press and release "LEARN" key twice.
5. Press the "SET"key.
All learned commands entries under that mode are now cleared.
TO CLEAR ALL STORED LEARNED COMMANDS, UNDER ALL MODES
1. Press and hold the "SET" key for 3 sec. about, until the LED indicator lights
continuously.
2. Release the "SET" key.
3. Press and release the LEARN key twice.
4. Press the "SET"key.
All Learned Command entries are now cleared.

"ALL 0FF" FUNCTION

Press and release the POWER key to turn off the selected appliance (for ex. TV).
The corresponding Mode key lights on during 1 second.
To switch oft all the appliances, proceed as follows:
1. Press and release the "ALL-OFF" key
The selected device turns off and the Mode key lights on
2. Press immediately again the ALL-OFF" key, during 3 seconds. All the preset
appliances turn oft one after the other, which can take 3 seconds. Then the
Mode key is off. The remote control must stay pointed at the appliances, until
the Mode key light turns oft.
The POWER key allows to turn on AND oft certain appliances. These devices will
be switched ON with "ALL-OFF" function, if they were 0FF just before.
EN-18