Setting The Temperature; Ironing Without Steam - Bosch Sensixx B20L Gebrauchsanleitung

if the "steam ready" lamp (8) lights and steam
is not released when pressing the steam
release button (14, 15*), refill the water tank.
Important:
• normal tap water can be used.
To prolong the optimum steam function, mix
tap water with distilled water 1:1. if the tap
water in your district is very hard, mix tap water
with distilled water 1:2.
you can inquire about the water hardness with
your local water supplier.
• The water tank can be filled at any time while
using the appliance.
• To avoid damage and/or contamination of the
water tank and the boiler, do not put perfume,
vinegar, starch, descaling agents, additives or
any other type of chemical product into the water
tank.
any damage caused by the use of the
aforementioned products, will make the
guarantee void.
• The iron is not designed to rest on its heal.
please always position it horizontally on the
iron pad (2*).
model dependent:
The iron pad can be placed into the specially
designed recess on the appliance or
somewhere suitable alongside the ironing
area.
Never rest the iron on the appliance without
the iron pad!.
• During it first use the iron may produce certain
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes
• While the steam release button is pressed, the
water tank may produce a pumping sound,
this is normal, indicating that water is being
pumped to the steam tank.
Setting the
temperature
1. Check the ironing instruction label on the
garment to determine the correct ironing
temperature.
2. Turn the temperature selector (13) to the
required setting:
•
Synthetics
••
Silk – Wool
•••
Cotton – linen
3. The indicator lamp (15) will remain lit while the
iron is heating and go out as soon as the iron
has reached the selected temperature.
Tips:
• Sort your garments out based on their cleaning
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
• if you are not sure what the garment is made
of then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
B
Ironing with steam
1. Turn the temperature selector (13) to the
required setting.
2. press the steam release button (14) to release
steam.
attention:
• When ironing on a lower temperature setting
"•", only press the steam release button (14) for
a few seconds at a time.
if you find that water is dripping out of the
soleplate, set the temperature to a higher
position (take care that the garment can be
ironed on this heat temperature setting).
• at the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
Tip : for better ironing results, iron the last
strokes without steam to dry the garment.
Cork HaNDlE IroN
(model dependent):
To get permanent steam, press the lock button
(16*) and slide it backwards until it locks. To
switch off the permanent steam, slide the lock
button forward.
Important:
• The steam hose may get hot if you are ironing
for long periods.

Ironing without steam

1. Begin ironing but without pressing the steam
release button.
15
B OSCH