Wall Mount - Philips AVENT SCD620 Bedienungsanleitung

28
English
OPERATING TIME / RANGE
VIDEO DISPLAY
Question
Why do I get
interference on the
parent unit? Why does
the video display on the
parent unit flicker?
Why isn't there any
image on the video
display while the
link light is green?
Why isn't the image on
the video display clear?

Wall mount

The volume of the parent unit may be set too high, which causes the parent
unit to consume a lot of energy. Decrease the volume of the parent unit.
As any other rechargeable electronic device, the battery capacity decreases
after a long period of usage.
Answer
Interference may occur when the parent unit is out of range of the baby
unit. Interference may also occur if there are too many walls or ceilings
between the parent unit and the baby unit or when other 2.4 GHz wireless
devices are switched on (e.g. microwave, Wi-Fi router).
Put the parent unit in a different place, closer to the baby unit, or switch off
other wireless devices.
The rechargeable battery of the parent unit may need to be charged.
The parent unit may be in the AUDIO, VOX or ECO mode. Press the mode
button on the right side of the parent unit to switch modes (see 'Modes').
The display brightness may be set too low. Increase the display brightness
on the parent unit using the control button in the centre.
Perhaps the lens of the baby unit is dirty. Clean the lens with a dry cloth.
The baby unit may be too far away from your baby. Make sure the baby
unit is not further than 1.5 meters / 5 feet away from your baby for optimal
video quality. Closer than 1 meter / 3.5 feet increases strangulation hazard.
Printing instructions:
Print this page in scale 100% and use the template to accurately mark the
position of the holes for the screws on the wall.