Ayce RMB46 SHW BS500E 2.6 PS Original Bedienungsanleitung Seite 94

Before you start mowing, you should run through this process several times in or-
der to ensure that the lever and actuator cables are working properly.
Repeat the test several times after the engine has started up. When the engine
start/stop lever is released, the engine must stop within a few seconds. If not, con-
tact Customer Service.
Danger: The blade begins to rotate as soon as the engine is started.
6.1 Starting the engine
For detailed information on starting the engine, refer to the enclosed manual
from Briggs & Stratton.
Drive unit
Drive lever/clutch lever (Fig. 5a/Item 2):
If you press this (Fig. 5c) the clutch for the drive will be closed and the lawnmower
will start to move with the engine running. Release the drive lever in good time
to stop the moving lawnmower. Practice starting and stopping before you use the
mower for the first time until you are familiar with controlling the mower.
6.2. Adjusting the cutting height
Warning! Adjust the cutting height only when the engine has been switched off.
•
The cutting height is centrally adjusted with the cutting height adjustor lever
(Fig. 6/Item 8). Different cutting heights can be selected.
•
Actuate the adjustor lever and pull it to the required position. Let the lever
click into position.
5c
2
Anl_RMB_46_2_S_HW.indd 94 Anl_RMB_46_2_S_HW.indd 94
6
1
8
24.11.15 13:41 24.11.15 13:41