Technical Characteristics - Nice Spin10KCE Anweisungen Und Hinweise

8) Technical characteristics

Nice S.p.a., in order to improve its products, reserves the right to modify their technical characteristics at any time without prior notice. In
any case, the manufacturer guarantees their functionality and fitness for the intended purposes.
All the technical characteristics refer to a room temperature of 20°C (±5°C).
Technical characteristics: SPIN
Model:
Type
Pinion
Peak thrust
[corresponds to the force necessary to start
a leaf]
Nominal torque
[corresponds to the force necessary to keep
a leaf moving]
Speed under no load
[corresponds to if "Fast" speed is
programmed]
Nominal torque speed
[corresponds to if "Fast" speed is
programmed]
Maximum frequency of operating cycles
Maximum continuous operating time
Operating limits
SPIN Power Supply
SPIN/V1 Power supply
Max. absorbed power
Insulation class
Emergency power supply
SPIN Courtesy Light
SPIN/V1 Courtesy Light
Flashing Light Output
STOP Input
Step-by-step Input
Radio AERIAL Input
Radio receiver
Programmable functions
Recognition functions
Operating temperature
Use in acid, saline or potentially explosive
atmosphere
Protection class
Dimensions and weight
Guide technical characteristics
Model:
Type
Guide length
Guide height
Useful stroke
Belt width
Belt height
Resistance to traction
26
Electromechanical gearmotor for the automatic movement of garage doors for residential
use, complete with electronic control unit
Diameter 9.5 mm, 28 teeth; for guides SNA11 and guides supplied with SPIN10KCE
The control unit enables programming 2 speeds equal to approx. 100% - 60% approx.
30 cycles per day (the control unit allows up to the maximum described in tables 3 and 4)
3 minutes (the control unit limits the continuous operation up to the maximum described in
tables 3 and 4)
In general, SPIN is suitable for the automation of sectional or overhead doors which remain
within the dimensions stated in table 2 and limits specified in Tables 3 and 4.
1 (a safety grounding system is required)
For 1 LUCYB flashing light (12V, 21 W)
For normally close or normally open contacts or for constant resistance
8,2KΩ with self-recognition (any variation from the memorized status causes the "STOP"
command)
For normally open contacts (the closing of the contact causes the "STEP-BY-STEP" command)
52Ω for RG58 or similar type of cable
Incorporated
6 ON-OFF functions and 6 adjustable functions (see tables 15, 15a and 17, 17a)
Recognition of the type of "STOP" device (NO or NC contact or 8,2KΩ resistance).
Recognition the door opening and closing positions and calculation of the slowdown and
partial opening points.
IP 40 use only in indoor or protected environments
Guide in SPIN10KCE
3-piece profile in galvanised steel
3.15m
35mm
2.6m
6m
6mm
730N
SN6011
9.9Nm
[550N]
4.95Nm
[275N]
103 rpm
[0,14m/s]
52 rpm
[0,07m/s]
230Vac (±10%) 50/60Hz.
120Vac (±10%) 50/60Hz.
200W
No
12V-21W BA15 socket
12V-21W BA15 socket
-20°C ÷ 50°C
No
225 x 330 h 100 / 3,3Kg
single profile in galvanised steel
SNA11
3.15m
35mm
2.6m
6m
6mm
730N