Maintenance - Ayce 5914 Originalbetriebsanleitung

• Apply uniform sanding pressure to extend the life of the sanding sheets.
• Intensifying the sanding pressure does not lead to an increase of the sanding
capacity, but instead it increases wear on the machine and the sanding sheet.
• Use only the tip or an edge of the sanding sheet for precise sanding of edges,
corners and hard to reach areas.
• When selectively sanding on one spot, the sanding sheet can heat up considerably.
Remove the tool from the surface periodically to permit the sanding sheet to cool
down.
• A sanding sheet that has been used for metal should not be used for other
materials.
• Use only original sanding accessories. For sanding, always connect dust
extraction.
b. Scraping
The tool is suitable for scrapping and removing surface coverings. For scraping, select
a high speed setting.
• To remove surface covers, place the scraping blade vertically on the work piece.
• Switch the tool on and cut down through the covering.
• Place the tool at a flat angle (not over 20°) and apply alight forward pressure to
remove the covering.
c. Cutting
Saw blades are ideal for making precise cuts in tight areas, close to edges or flush to a
surface.
• Select the lowest speed for making initial plunge, start off at lowest speed for
increased control. After making your initial cut, you can increase speed for faster
cutting ability.
• Flush cutting blades are intended to make precise cuts to allow for installation of
flooring or wall material. When flush cutting, it is important not to force the tool
during the plunge cut. If you experience a strong vibration in your hand during the
plunge cut, this indicates that you are applying too much pressure. Back the tool
out and let the speed of the tool do the work. While keeping the teeth of the blade in
the work surface, move the back of the tool in a slow sideways motion. This motion
will help expedite the cut.
• The flat saw blade is ideal for making precise cuts in wood, plaster, drywall
material.
• Applications include cutting openings in flooring for venting, repairing damaged
flooring, cutting openings for electrical boxes. The blade works best on softer
woods such as pine. For harder woods, the blade life will be limited.
• The flat saw blade can also be used for window restoration making glazing easy
to remove. The saw blade can be placed directly against the edge of the window
frame, guiding the blade through the glazing.

MAINTENANCE

CAUTION!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
112 | 113 GB