Operation - Ayce 5914 Originalbetriebsanleitung

2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
10.8V 1.5Ah li-ion
battery pack
Li-ion 10,8V
1,5Ah
7500-15000/min
Rotational speed
min -1
7500-
15000
With a LED work
light to illuminate
the work area
LED
95X95X95mm
sanding paper
95x95
x95mm
30min Charging
time
30min

OPERATION

1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
Remove battery pack (Fig.2)
Fig. 2
Battery charging (Fig.3)
Fig. 3
104 | 105
To remove the battery, press the battery
release buttons and pull the battery out of
the machine. Do not exert any force.
The battery pack for this product has been
shipped in a low charge condition. Charge
it fully before first use
The QuickBoost function charges a fully
depleted battery pack to approximately
20% capacity in 3 minutes in a normal
operating temperature: between 50°F
(10°C) and 140°F (60°C).
1. Connect the charger to a suitable
power supply, the red Defect light,
green Normal light and yellow
QuickBoost light will come on for one
second and then go out.
2. Align the raised ribs on batter pack
with the grooves in the charger insert
the battery pack into the charger
making sure the battery pack is fully
seated.
3. The charger will communicate
with the battery pack to evaluate the
condition of the battery pack.
GB