Ayce 5914 Originalbetriebsanleitung Seite 56

Sanding sheets
1. Sanding sheets are available with different grain sizes (grit), the higher the
number the finer the grain size.
2. Use a coarse grit to sand down rough finishes, medium grit to smooth the
work and fine grit to finish off.
3. It is best to make a trial run on a scrap piece of material to determine the
optimum grade of sanding sheet for a particular job.
SANDING SHEET GRIT CHART
Grit Type
60 or less Very Coarse
80-100 Coarse
120 – 150 Medium
180 – 220 Fine
240 or more Very Fine
Variable speed control (Fig.6)
Fig. 6
LED work light (Fig.7)
Fig. 7
Example of use
Material removal, heavy paint removal,
shaping wood
Paint removal, rough surface preparation
(e.g. non-planed wood)
Surface preparation planed wood
Sanding between coats
Final finishing
The variable speed feature of this tool
enables the speed to be adjusted
according to the accessory being used
and material being cut, scrapped or
sanded.
The speed dial is numbered "1" through
"6", with position "1" being the lowest
speed and position "6" being the highest
speed.
The tool has LED light to illuminate the
work area and improve vision when
working in areas with insufficient light.
The LED light will switch on automatically
while the on/off switch is turned on.
Do not look directly into LED light.
!
WARNING
Fein adaptor (Fig.8)
Fig. 8
Switch on and off (Fig.9)
Fig. 9
3. Operation for working
a. Sanding
Do not touch the gear box after prolonged use; it could be very hot.
!
WARNING
• The removal rate and the sanding pattern are determined by the choice of sanding
sheet and the work surface.
110 | 111
NOTE: The accessories supplied are not
sold separately. If they become damaged,
the Fein adaptor can be used to install
Fein accessories
1. Put the "Fein Adaptor" on the
attachment plate.
2. With your gloved hand holding
the accessory, insert and depress
the flange bolt until you hear a click
indicating that the accessory is
secured. Press flange bolt, then turn
the flange bolt anticlockwise at 90°.
To turn the tool ON, push the on/off switch
forward. To turn it OFF, push the switch
backward.
GB