Installation; Supply Of Combustion Air; External Air Connection - WANDERS Pecan Eco Serie Bedienungsanleitung Und Montagevorschriften

GB
8. Never cover the chimney breast with combustible material (e.g. paper covering).
9. The wall behind the stove must consist of, or be insulated with, fire-proof materials. The insulation material must resist a
temperature of 700 °C and have a density of 80 kg/m3. Please see for insulation materials table page below).
Table for insulation material. Please note: only use the products that are mentioned in the marked area.
Insulation
Nr. Art.
10 mineral wool
11 glass wool
12 rock wool
13 waste products
Select the insulation material from this table. Group 99 is NOT ALLOWED
Never leave the optional wooden part of the handle in the steel ring while using the fireplace. The handle
must only be used to open and close the door; once used, put it back in a safe place. The wood will discolour
over time - this can not be avoided.

Installation

The Pecan Eco is tested in accordance with the international EN 13240 standardization, and has an extra additional
standardization for optimally environment-friendly heating devices related to flue gases. The stove can be connected to a flue
tube to which several stoves are connected. The pipe for flue gas extraction has a diameter of 150 millimetres (connection 146
mm external). The Pecan Eco must never be built in.

Supply of combustion air

The stove must have enough supply of fresh combustion air. If necessary, make an extra air supply opening as close to the
stove as possible to avoid draught. An extra opening for air supply is always required if:
• the space has a heat recovery system.
• the space has a central exhaust system.
• there is a cooker hood in the same space.
The air supply opening must be closable if it goes through a fire-resistant wall. When there are several combustion devices in
the same space there must be enough air openings to guarantee proper combustion.

External air connection

The fresh air supply channel has a diameter of 80 millimetres. The air supply channel can be fitted via a bottom or rear
connection. If the external air supply goes through a firewall, that channel must be able to be shut off. If the channel is longer
than 1 meter, including a bend of 90 degrees, the channel's diameter will need to be increased.
To adjust the position of the external air supply, switch the connection piece with the cover plate by unscrewing the bolts on
the respective components.
24
Packed Thermal conduction
Nr. Form Nr.
01 bands 01
02 loose wool
03 wool 02
granule
04 felt
05 lamella mats 10
06 stitched mats 11
07 plates
08 scales
09 segments 20
10 interwoven
21
99 others 99
Max. appl. temp.
Packed Nr. °C
stitched mats 10 100
stitched mats 12 120
stitched mats 14 140
g. curve 2 16 160
g. curve 1
g. curve 2
72 720
plates 74 740
g. curve 1 76 760
plates
g. curve 2
single 99
Density
Nr. kg/m
3
02 20
03 30
04 40
05 50
06 60
07 70
08 80
09 90
10 100
11 110
12 120
13 130
18 180
99