Your Economic Stove At A Single Glance; Installation; Lighting The Stove - WANDERS Economic Gebrauchsanweisung Und Montage Vorschriften

Your Economic stove at a single glance

One of the Economic models
The Economic hearth is a combination of comfort and
efficient heat output. The stove has an outer cover and
an interior chamber which ensures the radiation of 70%
heat output through convection to the room, while the
remaining 30% of the heat is released through radiation
via the glass area. The integrated flue gas deflector makes
the flue gases circulate through the interior chamber
to increase the heat output of your stove. Though not
without sound, the 1 or 2 integrated ventilators draw in
cold air from underneath the stove and lead the air up via
the backside and blow it out again via the front side. The
velocity of the ventilators can be manually adjusted.
The hearth is equipped with an automatic thermostat
valve which regulates the air intake to your woodstove
via the ash pan. Open the valve completely when
lighting the stove. Once the stove has heated up, the
valve will close automatically to minimize the chance
of overheating provided that the other air inlets remain
closed. Please don't forget to clean the ash pan regularly
to ensure optimum air supply.

Installation

It is common practice for the dealer where you purchased
your Economic stove to also take care of installing it. If
this is not the case, please ensure that the installation
is done by a certified installer. A certified installer can
also give you the right advice about the flue tube to
which the stove must be connected. Connecting wood-
burning stoves by unqualified persons is prohibited, in
which case we cannot give any guarantee about proper
functioning of your Economic stove. Please bear the fire
safety in mind when installing the stove. See also page
24.
The wood-burning stove is suitable as an extra heat
source and does not replace your principal heating
device.
Usage early in autumn or late in winter
When the external and internal temperatures do
not differ much, a proper chimney draught is a real
challenge. You can help chimney draught get started
by burning some wood while keeping all air inlets
maximally open. An abundant air supply speeds up
quick heating which in turn increases the draught
in the chimney. Lighting up the stove with only a
little wood prevents smoke from streaming into the
room.

Lighting the stove

The stove will become very hot when you light it and
will need at least two hours to cool off. Don't touch the
stove without protection during firing and for two hours
after. Handle the stove always with a glove to avoid
getting serious burns.
Open the door
19