Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
to take your juicer apart
1 Remove the pulp collector by
pressing the pulp collector catch
and sliding the collector out.
2 Unlatch the lid and lift off.
3 Remove the filter and filter holder
together. Then separate for cleaning.
care and cleaning
Before cleaning, unplug your juicer.
G
If the filter is too tight to remove, wait
G
a few minutes until it loosens up.
Some foods, eg carrot, will discolour
G
the plastic. Rubbing with a cloth
dipped in vegetable oil helps remove
discolouring.
motor unit
Wipe with a damp cloth, then dry.
G
Do not immerse in water.
G
Store excess cord in the storage
G
area at the back of the power
unit
.
filter
Clean using the brush supplied.
G
Note: Use the flat end of the brush
to remove pulp from the lid.
Check the filter regularly for
G
signs of damage. Do not use if
the filter is damaged. Refer to
"service and customer care"
other parts
Wash in hot soapy water, then dry.
G
Alternatively they are dishwasher
G
safe and can be washed on the top
rack of your dishwasher. Avoid
placing items on the bottom rack
directly over the heating element. A
short low temperature (Maximum
50°C) programme is recommended.
service and customer
care
If the cord is damaged it must, for
G
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you experience any
G
problems with the operation
of your juicer, before calling
for assistance refer to the
troubleshooting guide.
If you need help with:
using your juicer or
G
servicing or repairs
G
Contact the shop where you bought
G
your juicer.
Designed and engineered by
G
Kenwood in the UK.
Made in China.
G
5
Werbung
Inhaltsverzeichnis
