Care And Cleaning; Service And Customer Care - Kenwood JE450 Bedienungsanleitungen

to use your citrus juicer
1 Fit the glass bowl
base turn clockwise to secure.
Then fit onto the power unit.
2 Fit the anti-drip spout
the juicing position
= juicing position
= anti-drip position.
3 Place the strainer
bowl , then add the cone
4 Put a jug under the spout
catch the juice.
5 Cut the fruit in half and place each
half on the cone.
Operate the juicer by either:
G
lowering the handle onto the fruit
G G
or
press the fruit down by hand
G G
the juicer will operate
G G
automatically.
For best results store and juice the
G
fruit at room temperature and hand
roll on a worktop before juicing.
To help with juice extraction move
G
the fruit from side to side when
operating by hand.
When juicing large quantities, empty
G
the strainer regularly to prevent the
build up of pulp and seeds.
6 To stop the juicer, release the handle
upwards, lift the fruit from the cone
and wait until the final flow of juice
has reduced to a few slow drips.
Then turn the spout so that the anti-
drip position
before removing the jug.

care and cleaning

Always switch off, unplug and
G
dismantle before cleaning.
Remove the anti-drip spout for
G
cleaning.
Replace dust cover after use and
G
put handle in the locked position
for storage.
power unit
Wipe with a damp cloth, then dry.
G
Do not immerse in water.
G
Store excess cord in the storage
G
area at the back of the power
unit .
to the bowl
and turn to
uppermost.
inside the glass
.
to
is uppermost
press
Remove the press for cleaning by
G
turning anti clockwise.
After cleaning insert the press into
G
the handle and turn clockwise to
secure.
glass bowl and base
Separate the bowl and base for
G
cleaning by turning the bowl anti
clockwise.
After cleaning fit the bowl and turn
G
clockwise to secure.
Wash all parts in hot soapy water,
G
then dry.
Alternatively they are dishwasher
G
safe and can be washed on the top
rack of your dishwasher. Avoid
placing items on the bottom rack
directly over the heating element. A
short low temperature (Maximum
50°C) programme is recommended.
service and customer
care
If the cord is damaged it must, for
G
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your appliance or
G
servicing or repairs
G
Contact the shop where you bought
G
your appliance.
Designed and engineered by
G
Kenwood in the UK.
Made in China.
G
3