Installation; Filtering Version - De Dietrich DHL7173X Installationsanleitung

2
•

INSTALLATION

Take the product out of the packaging
and place it on a suitable surface: we
suggest to use a soft material like a
sponge or a cloth.
This information is very important for the
creation of the plasterboard structure.
Installation entails the lowering of the
plasterboard ceiling, as the appliance
shall be installed at a maximum distance
of 2100mm from the floor in order to en-
sure good operation and performances
The hood can be installed at a minimum
distance of 300mm and at a maximum
distance of 480mm from the solid ceiling.
In case ceiling lowering results grea-
ter than the aforementioned maximum
distance required, you will need to use
longer threaded bars.
In order to make installation operations
easier, we suggest to create only the me-
tal structure close to the hood, without
using the plasterboard.
Please remind that the recess which will
house the hood should be 1065x665mm
and that the weight of the plasterboard
shall not rest on the hood.
Provide the area where the hood is being
installed with power supply and with the
150mm diameter or similar section duct
necessary to discharge the air.
Draw the holes for installing the applian-
ce on the solid ceiling (Fig. 3).
Drill the holes previously outlined using
an 8mm diameter twist drill and secure
the metric dowels and the threaded bars
supplied into the holes (fig. 4).
The appliance has the motor air out-let
positioned on its short side; nevertheless
you can choose the side of the hood from
which collected air is to be discharged as
follows: open the panel, following the in-
structions given in the 'USAGE' section
and remove the grease filters.
Remove the 4 screws, as shown in figu-
re 5.
Remove the lower plate , as shown in
figure 6.
Remove the motor fixing screws, as
shown in figure 7.
Make a hole either in the centre of the
hood top side (fig.8) or long side (fig. 9).
Fix the metal cover where the motor was
previously placed using the four screws
supplied. (fig.10).
If you choose to install the motor with
the air outlet directed upwards, installa-
tion will not entail the use of the motor
supporting metal plate , as the motor will
be fixed directly on the hood body, as
shown in figure 11.
Bring the hood close to the ceiling and
carry out the electrical and the air out-let
duct connection as well.
Install the hood on the ceiling and secu-
re it by screwing the nuts supplied to the
threaded bars. (fig.12).
If you choose to have the air outlet on the
hood short side, the exhaust duct fixing
operations can be made easier by remo-
ving the cover shown in fig. 13.
The plasterboard structure shall not rest
on the hood.

FILTERING VERSION

In case the appliance is used in the fil-
tering mode, activated charcoal filters
need to be installed, as shown in Fig. 14.
The air out - let ducting for discharging
vapours outside the plasterboard recess,
shall also be provided in this case.
26