Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
36
Assembling the Remote Front Housing to Transceiver Box
1.
Connect the flex from the Transceiver unit to the Remote Front Cover PCB.
2.
Using screws provided assemble the Remote Front Cover to the Transceiver unit.
Installing the Remote Control Head
1.
Position the trunnion in the desired location and mark the positions of the mounting holes
using the trunnion mounting bracket as a template. Be careful that the housing is not affected.
2.
Centrepunch the marked spots and drill 4mm (5/32-inch) holes at each spot.
3.
Fix the trunnion in position using the supplied screws.
4.
Route the Remote Cable as required, feeding it through the bracket (a 20mm hole is required
for the cable plug).
5.
Push the cable plug into the Remote Front and Back Cover until it snaps into place.
6.
Snap the assembly into the trunnion.
7.
Adjust the assembly as required then fix it in position with the wing screws supplied.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
Figure 11 Remote Mount Head in Trunnion
INSTALLATION
Werbung
Kapitel
Inhaltsverzeichnis
