Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
28
Trunnion Installation
Installation Planning
The trunnion allows the terminal to be mounted to a variety of surfaces.
1.
The trunnion must be securely fixed to the vehicle chassis.
2.
Ensure the surface can support the weight of the terminal.
3.
Although the trunnion can be mounted to a plastic dashboard, it is recommended that the
mounting screws be located so they penetrate the supporting metal frame of the dashboard.
2x Wingscrews
0305760W02
Installation Procedure
1.
Select either the transmission hump or an open underneath portion of the dash to mount your
terminal. (See Figure 6 Transmission Hump Mounting (Top) and Below Dash Mounting (Bot-
tom)). When mounting the trunnion on the transmission hump, be careful that the transmis-
sion housing is not affected.
2.
Use the trunnion mounting bracket as a template, to mark the hole positions on the mounting
surface. Use the innermost three holes for a curved mounting surface, such as the transmis-
sion hump, and the three outermost holes for a flat surface such as under the dash.
3.
Center-punch the spots you marked and use a 4 mm (5/32-inch) bit to drill a hole at each
location.
4.
Secure the trunnion mounting bracket to the mounting surface with the three self-tapping
screws provided. (See Figure 6 Transmission Hump Mounting (Top) and Below Dash Mount-
ing (Bottom)).
5.
Slide the terminal into the trunnion. Secure the terminal with the two wing screws provided.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
Figure 5 Terminal into High Profile Trunnion (GLN7317)
INSTALLATION
Werbung
Kapitel
Inhaltsverzeichnis
