Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Product Safety and RF Exposure
Installation Requirements for Compliance with Radio
Frequency (RF) Energy Exposure Safety Standards
This radio is intended for use in occupational/controlled conditions, where users have full knowledge
of their exposure and can exercise control over their exposure to meet FCC limits. This radio device is
NOT authorized for general population, consumer, or any other use.
To ensure compliance to RF Energy Safety Standards:
•
Install only Motorola approved antennas and accessories.
•
Be sure that Product Safety and RF Safety Booklet enclosed with this radio is available to the
end user upon completion of the installation of this radio.
Before using this product, the operator must be familiar with the RF energy awareness information and
operating instructions in the Product Safety and RF Exposure booklet enclosed with each radio
(Motorola Publication part number 6866537D37) to ensure compliance with Radio Frequency (RF)
energy exposure limits.
For a list of Motorola-approved antennas and other accessories, visit the following web site which lists
approved accessories for your radio model:
http://www.motorola.com/governmentandenterprise
Only specialized workshops should be contacted for installation, maintenance and repair work.
This unit is equipped with protection fuses in the Power and Ignition Sense Cable.
Replace these fuses only with the original ratings!
Caution:
Failure to use correct manufacturer-approved parts may result in physical
damage to this unit.
Fuse for Power Cable GKN6270/GKN6274:
Fuse for Ignition Sense Cable HKN9327:
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
IMPORTANT SAFETY INFORATION
ATTENTION!
ADDITIONAL IMPORTANT INFORMATION FOR
SERVICING AND INSTALLING THE TERMINAL
10A (Motorola Part Number: 65C80283E05)
4A (Motorola Part Number: 65C80283E02)
3
Werbung
Kapitel
Inhaltsverzeichnis
