Ignition Sense Cable Installation - Motorola Cleartone CM5000 Installationshandbuch

26

Ignition Sense Cable Installation

Number Description
HKN9327 Ignition Sense Cable with fuse 4A
6580283E02 Fuse 4A for Ignition Sense Cable
The HKN9327 Ignition Sense Cable allows the terminal to be turned on and off by the vehicle
ignition switch.
The ignition sense cable kit contains a thin cable and a fuse holder. To install the cable, carry out the
following steps.
1. Plug the lead of the Ignition Sense Cable with the crimped on terminal into #10 socket of the
accessory plug.
2. Route and secure the cable with attached tie wrap.
3. Connect the other lead of the accessory cable to the ignition switch of the vehicle.
4. Insert the fuse into the fuse holder and close the cover.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
Table 2 Ignition Sense Cable
15
16
Figure 3 Accessory Connector with Ignition Sense Cable
Rating
Ignition Sense Cable, Length: 3 m
Radio expects on modern vehicles, an available line from
Ignition High voltage only during engine start, and this is
removed on returning the ignition switch to the running
condition.
In case of blown fuses, replace ONLY with those of identi-
cal value.
NEVER insert ones of different values.
Ensure that the fuse is removed during cable installation.
1
10
2
INSTALLATION