Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Introduction
General Information
There are two methods of installing the mobile terminal in a vehicle:
1.
Using the direct mounting trunnion and power cables supplied with a standard radio package.
2.
Remote mounted in the car radio cut-out (using the required Universal DIN mounting kit
GMLN4740A), per ISO7736.
An accessory connector on the rear of the terminal enables you to attach different accessories (see
section "Accessory Connection Plan").
A 10-pin telephone type connector (TELCO) on the front control head panel (see page 44) provides
for the connection of various types of microphones (desktop microphone RMN5069, telephone style
handset GMUN1006).
1.
Mount the terminal horizontally near the driver, so the driver can easily view, access and oper-
ate the controls and accessories.
2.
Ensure that the location is not exposed to dirt and moisture.
3.
Verify that there will be sufficient space around the mobile unit for air flow and installation.
4.
Check that there is enough routing space for the power cable connector and the antenna
coaxial cable.
5.
Plan the best place to run connections to minimize pinching, crushing, and overheating of
wires and cables.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
This Terminal is only designed and certified to be used for
terrestrial use only.
This product must be installed in a vehicle in accordance
with the vehicle manufacturer's guidelines and the
instruction detailed in this manual.
Only the specified Motorola parts in this manual should
be used. Failure to do so could result in non compliance
to the Automotive Directive (72/245/EEC, as amended by
95/54/EC).
Note, for products fitted to two and three wheeled
vehicles, Directive 97/24/EC applies.
This terminal is ONLY made for 13.2 V power supply con-
nection. In vehicles with 24 V power supply, a DC/DC con-
verter is required.
Please be aware when planning the installation that there
is a current con-sumption of approx. 6.3A during PTT and
1.6mA even when the terminal is switched off.
INSTALLATION
21
Werbung
Kapitel
Inhaltsverzeichnis
