Troubleshooting; What To Do If; Customer Service - KKT KOLBE ANGOLO Benutzerhandbuch

Troubleshooting

5. Troubleshooting

5.1 What to do if ...

...the motor does not work:
• Is there a power supply failure?
• Is the plug properly inserted in the
socket?
• Is the fuse blown?
...the hood capacity is insufficient /
operating noise has increased:
• Is the distance between hood and
hob excessive? (please see 3.1)
• Is the size of the exhaust air pipe-
line sufficient? (please see 3.3)
• Is the exhaust air duct blocked?
• The air flow can be obstructed if the
wall box is fitted with a fly screen
If this is the case remove the fly
screen.
• If the cover plate of the wall box
has fixed, very inclined louvres, you
should remove the plate to check
whether this solves the problem.
Mount a cover plate with movable
louvres in the wall box, as this will
least obstruct the air flow.
• Is / are the filter(s) clean?
• Was / were the carbon filter(s) ins-
talled more than six months ago?
Then this/these should be changed.
• Is the air taken from the kitchen
being replaced by sufficient fresh
air, so that no partial vacuum is
being produced in the room?
• Are there excessive draughts from
open doors or windows?
...the lightning fails:
• Does the lamp have to be changed?
• Has the lamp been properly fitted
and seated in the holder up to the
stop?
• Is the power connected??
...the appliance vibrates / is unstable
• Is the motor firmly mounted?
• Is the appliance correctly mounted
and are the fixing brackets properly
tightened?
If all the above checks fail to remedy
the fault, it is possible you have a
more serious problem.
In no circumstances try to repair the
electronic/electrical components in
the appliance.
Contact your Customer Service.

5.1 Customer service

For technical queries concerning your
appliance please contact the custo-
mer service office of your dealer.
The type and rating plate is located
inside the appliance (remove the
grease filter).
35