Standard And Optional Accessory; Wood Moisture Measurement Using Electrodes M - GANN Hydromette RTU 600 Betriebsanleitung

4.6 Admissible ambient temperatures
Storage:
5 to 40 °C; temporarily -10 to 60 °C
Operation:
0 to 50 °C, short term -10 to 60 °C not condensing
The meter including accessory must not be stored or used in aggressive air or air contaminated by solvents.

5.0 Standard and Optional Accessory

Drive-in Electrode M 20
for surface and subsurface measurements on wood up to 50 mm thick. Also for testing chipboard, fibreboard
and set construction materials (plaster, mortar, etc.), with measuring pins
Stick-in Electrodes M 6
for testing hard building materials, using contact paste and pre-drilled holes, with pins
Contact Paste
to ensure good contact between electrode pins and tested building materials. For moisture measurements
in hard building materials (cement flooring, concrete, etc.) with electrodes M 6
Active Electrode B 50
with integrated measuring circuit, designed for nondestructive location of moisture concentration in con- struction
materials and moisture distribution in walls, ceilings and floors.
It works according to a patented measuring procedure and generates a concentrated high frequency field
with substantial penetration depth.
Measuring range:
Special electrode RF-T 28
with integrated measuring circuit, for measurement of air humidity air temperature, complete with connection
cable Measuring range: 7 to 98 % RH and -10 to +80 °C.
Response time: about 20 seconds for 90 % of the humidity difference at an ambient temperature of 20°C, or about
120 seconds for 90 % of temperature variation.
Temperature Probe OT 100
Spring loaded, low mass surface temperature probe, e.g. for wall surfaces, etc., measuring range -50 to +250 °C.
Measuring Cable MK 8 for connection of the electrodes M 6, M 20,
6.0 Operating Instructions for Wood Moisture Measurement Using electrodes M 20
Set selector switch »X« (4)
to the first figure of the two-digit code number stated in the table of wood species for the species to be tested.
Set selector switch »Y« (5) to the second figure of the two-digit code number stated in the table of wood
species for the species to be tested.
Set selector switch (6)
to the temperature of the wood to be tested.
Connect measuring electrode
to the meter socket (1) by means of the measuring cable MK 8.
Drive-in, stick-in or press the electrode onto the wood to be measured.
Press measuring key (7) and read off result displayed by the LCD readout as soon as the reading has sta-
bilised. Press measuring key no more than three seconds.
15.11.2006
0 to 199 digits, classification by table.
0.3 to 8.5 % of dry weight, conver-sion by table according to material tested.
0.3 to 6.5 % CM, conversion by table according to material tested.
Hydromette RTU 600 #013629
15