Battery Status, Status Indication And Charging - Vermeiren Sedna Gebrauchsanweisung

EN
NL
3.5
3.5.1 Battery status and status indication
The indicator lights of the status indication and battery status will go on as soon as the scooter
is switched on, see next figure.
•
Check if all lights are on (if the battery is fully charged, see next)
Status (fault) indication (21)
Battery-status indication (24)
•
Only use the batteries that are part of the scooter delivery. Contact your specialist dealer
for possible replacement.
•
Under no circumstances is it allowed to open or change the battery nor to change its
connection points!
•
Protect the battery and battery charger against flames, high temperatures (>60°C),
moisture, sunshine, severe shocks (for example dropping). Do NOT use the battery if
this has been the case.

Battery status, status indication and charging

Battery-status and status indication
WARNING
Risk of injuries and damage due to fire
These red lights go on by switching the scooter on and next
they go out. In case of any problem these lights will blink
slowly. The number of blinks indicate the fault code. The
meaning of this code can be found in chapter 5.
The battery-status lights will go on from left to right after
switching on. When the battery is fully charged, all
blocks/lights will be on. Using the scooter will decrease the
battery charge and some of the lights on the right will go out.
The more lights are on, the higher battery charge is.
The batteries need to be charged again If only 3 red lights on
the left are on. Keep in mind that the scooter will automatically
stop during the ride when battery charge becomes to
low.(see chapter 3.2)
EN - 16
Sedna
2019-02
Using your scooter