Cognex In-Sight 7000 Gen2 Serie Handbuch Seite 12

3. Place the adapter on the faceplate of the vision system. Insert the four
adapter screws and tighten; the maximum torque is 0.90 Nm (8 in-lb).
4. Thread the lens into the vision system.
5. Attach the cover to the vision system. Rotate the cover clockwise
approximately thirteen degrees to lock it.
Install the Mounting Bracket (ISB-7000-7K)
Complete the following steps to attach the accessory mounting bracket (ISB-7000-
7K) to the vision system.
CAUTION:
The vision system should be grounded, either by mounting the vision
l
system to a fixture that is electrically grounded or by attaching a wire
from the vision system's mounting fixture to frame ground or Earth
ground. If a ground wire is used, it should be attached to one of the
four mounting points on the back plate of the vision system; not to the
mounting points on the front of the vision system.
When mounting the vision system to the mounting bracket, use the
l
M3 screws supplied with the mounting kit. If using the 1/4 - 20 or M6
screw holes on the mounting bracket to secure the vision system to a
mounting surface, the insertion depth of the screw should not exceed
7mm. Allowing the mounting screws to bottom in the mounting hole
can damage the vision system.
1. Align the mounting bracket with the mounting holes on the vision system.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex
wrench; the maximum torque is 0.90 Nm (8 in-lb).
11