INVENTOR K2-10LBS Bedienungsanleitung Seite 15

The dehumidifier
is not a chilling
device. What
could be the
cause of cold air
being extracted?
The unit does not start
Make sure the dehumidifier's plug is placed completely into the socket.
l
Check the house fuse/circuit breaker box.
l
Check whether the power cord is damaged.
l
Check the water tank, if it is full, empty it.
l
Check if the dehumidifier has reached its preset level.
l
Make sure the water tank is positioned properly.
l
Room temperature is lower or higher than the advised operational range.
l
Check whether the humidity level has been set in high levels.
l
Dehumidifier does not dry the air as efficient
Make sure that the dehumidifier has been operating enough time to remove the
l
moisture.
Make sure there are no curtains, blinds or furniture blocking the front or back of the
l
dehumidifier.
The humidity selector may not be set low enough.
l
Make sure you have cleaned the filters as suggested. Clogged filters may result in
l
reduced performance.
All house exits (windows doors etc) where the dehumidifier is operating, should be
l
shut.
Room temperature is below the advised operational range.
l
There is a kerosene heater or something giving off water vapor in the room.
l
The room that the device is placed is bigger than suggested.
l
The humidity level is too high.
l
The unit makes a loud noise when operating
The air filters are clogged.
l
The device is tilted instead of being in an upright position.
l
The floor surface is not flat.
l
EN
The dehumidifier operates by intaking condensed air
removing any moisture and sending it back in the area it
operates. If you are standing near the dehumidifier while
operating you may feel that the air coming out of the fan is
cooler due to the diffusion. In reality, it is at the same room-
temperature but with less humidity.
15