Medtronic Guardian 2 Link Bedienungsanleitung Seite 12

MP6025871-12C1 / A
Connecting the transmitter to the sensor
Before proceeding, have your pump user guide available.
To connect the transmitter to the sensor:
1 After the sensor is inserted, consult your serter user guide for details on applying the
required overtape.
2 Hold the rounded end of the inserted sensor to prevent it from moving during
connection.
3 Hold the transmitter as shown. Line up the two notches on the
transmitter with the side arms of the sensor. The flat side of the
transmitter should face the skin.
4 Slide the transmitter onto the sensor until the sensor's flexible
arms snap into the notches on the transmitter. If the transmitter
is properly connected, and if the sensor has had enough time to
become hydrated, the green light on the transmitter will flash
within 10 seconds.
5 If the transmitter light does not flash, disconnect the transmitter from the sensor, wait
for several seconds and then reconnect. If the transmitter light still does not flash,
charge the transmitter.
6 When the transmitter light flashes green when connected to the sensor, use your
pump to start the sensor. For more instructions, see your pump user guide.
7 After the transmitter successfully sends sensor data to the pump, attach the sensor's
adhesive tab to the transmitter.
8 Follow the instructions that appear on the pump screen or follow the instructions in
your pump user guide.
-6-