Led Indication Front Panel; Configuration Example - Safeline SL6+ Installationsanleitung

LED indication
front panel
LED 1 indicates the power supply status
Fig 3.1 -
Continuous green
Flashing red (400/400 ms)
Continuous red
LED 2 indicates active alarm and battery condition
Fig 3.1 -
Light off
Rapidly flashing yellow (200/200 ms)
Flashing red (400/400 ms)
Continuous red
LED 3 indicates the phone line's status
Fig 3.1 -
Flashing green (100/100 ms)
Flashing green (400/400 ms)
Slowly flashing green (200/4600 ms)
Continuous green
Flashing yellow (100/100 ms)
Flashing red (400/400 ms)
Continuous red
Reset button
Fig 3.1 -
Press for 3 sec
Press 3 times
Press once
Press 5 sec - release
p. 16
Configuration
example
If at any time you need to start
over, use the factory reset
command *99*1#.
Please refer to the full
configuration setup in the
"Parameter list" as these are
merely examples.
p.25
[DOCSxxxx] SL6 Quick guide 201811.indd 30
Mains power supply OK.
Battery operated, with power to the emergency light.
Battery operated, no power to the emergency light.
No active alarm/battery OK.
Active alarm not reset.
Battery check in progress.
Battery test failure/no battery connected.
Fire mode activated.
Call connection in progress.
Telephone line connected. / GSM network OK.
Call connected.
Incoming call.
No telephone line connected. / Searching for GSM network.
No SIM card (when using GSM).
Show GSM signal strength (see table below).
Start a self test (battery + bus initialization).
Resets an active alarm. Aborts calls in progress.
SL6+ turns off. NOTE: refers to battery powered only
Storing of two different telephone numbers, one to be answered by
P100 code and the other one with voice.
1. Start configuration:
0 0
2. 1st phone number:
* 1 1 * 1 2 3 4 5 6 7 8 #
3. 2nd phone number:
* 1 2 * 2 3 4 5 6 7 8 9 #
4. Call type 1st number:
* 2 1 * 0 #
5.
Call type 2st number:
* 2 2 * 1 #
6. Alarm button delay:
* 8 7 * 0 3 #
7. End configuration:
* 0 0 * #
30
- Example: Answered with P100 code.
- Example: Answered as voice call.
- Example: 3 seconds delay.
English
2019-02-21 15:10