Remote Control - Acme Payload Bedienungsanleitung

preparation for flight

remote control

• Recheck the playground; be sure that it is free from crowds,
animals and other barriers.
• Slide the throttle control stick down to the bottom.
• Turn on the remote controller and the power light will blink
slowly.
• Then slide the throttle control stick up to the top. The power light
will blink at a higher speed. return the throttle control stick to
the bottom; a beep sound will be heard and the power light will
keep flashing, which means that the remote controller is sending
out a connection signal. it will take about 10 seconds to finish
the signal connection process. once the signal connection is
completed, the power light will stay "on" without blinking and the
remote controller is set for the flight.
the drone
• Recheck the playground; be sure that it is free from crowds,
animals and other barriers.
• Slide the throttle control stick down to the bottom.
• Turn on the remote controller and the power light will blink
slowly. then slide the throttle control stick up to the top. the
power light will blink at a higher speed. return the throttle control
stick to the bottom; a beep sound will be heard and the power
light will keep flashing, which means that the remote controller is
sending out a connection signal. it will take about 10 seconds to
finish the signal connection process. once the signal connection
is completed, the power light will stay "on" without blinking and
the remote controller is set for the flight.
• To ensure a steady flight, please set the value of the trimmer to
the midpoint.
• Push up the throttle stick slowly and the drone will take off.
• To avoid any misunderstandings, we have defined the orientation
of the drone as follows: the drone is set to have the copter nose
facing straight ahead and the tail facing the pilot .the copter
nose direction is named as the "forward" position, while the tail
direction is "backward". the copter flying up to the sky is moving
"upward" while the copter flying down to the ground is moving
"downward". the pilot's left side is called "left", and the pilot's
right side is named the "right". all of the directions we talk about
in this manual are subject to the above definitions.
• The orange lights are at the front of the drone; the blue lights are
at the back of the drone.
• Check the rotation direction of the rotor blades which is shown in
pic. 18.
• If the drone keeps flying to one side, this can be corrected by
adjusting the trimmer on the remote control.
remarKS
• A signal connected between the drone and the remote control is
required for the first use.
• Set the connection one by one to avoid signal connection error.
• To better protect the battery, please unplug the battery cable
from the power wire after the use.
clockwise
(motor 2)
left
counter clockwise
(motor 1)
Pic. 16
Pic. 17
head of the counter clockwise
drone (motor 3)
right
clockwise
(motor 4)
tail of the
drone
Pic. 18
7