ACME Payload Bedienungsanleitung Seite 6

propellerS inStallation
Pic. 6
Pic. 9
1. there are 3 interfaces on each motor cabinet. insert the frame plugs into the interfaces and fix them in place. (Pic.9)
2. fix the protection frame by screwing it in clockwise. (Pic.10)
3. there are 4 interfaces on the bottom of the drone. insert the landing gear plugs into the interfaces and fix them in place.(Pic.11)
4. fix the landing gear by screwing it in clockwise. (Pic.12)
how to change the BatterY of the drone
Pic. 13
how to charge the drone BatterY
6
Pic. 7
Pic. 10 Pic. 11
Pic. 14
Pic. 15
1. Before the installation, please distinguish the clockwise propellers and the
counter-clockwise propellers. make sure that the clockwise propellers are
fixed on the clockwise motors and the counter-clockwise propellers are
fixed on the counter-clockwise motors (Pic. 6).
2. When installing the propellers, push up the gear component to make the
main shaft protrude, and then fully insert the main shaft into the propeller
(Pic.7).
Pic. 8
3. use a screw to lock the propeller by turning it clockwise (Pic.8).
Pic. 12
1. unplug the battery wire from the power wire plug of the drone and take out
the battery. (Pic.13)
2. Plug the new battery wire into the power wire plug of the drone and insert
the battery into the battery compartment. (Pic.14)
turn off the drone, unplug the battery cable from the power wire plug and
take out the battery. insert the charger into a power outlet, and the indicator
light will be green; connect the battery cable with the charger wire plug, and
the indicator will be red when the charging is proceeding. once the battery is
full charged, the indicator light will become green. full charging takes about
2.5 hours.
note: Battery should Be fully charGed Before storinG.