Flex L 3309 FRG Bedienungsanleitung Seite 15

Angle grinder
Position the cord clear of the spinning

accessory.
If you lose control, the cord may be cut or
snagged and your hand or arm may be
pulled into the spinning accessory.
Never lay the power tool down until the

accessory has come to a complete stop.
The spinning accessory may grab the
surface and pull the power tool out of your
control.
Do not run the power tool while carrying it

at your side.
Accidental contact with the spinning
accessory could snag your clothing,
pulling the accessory into your body.
Regularly clean the power tool's air vents.

The motor's fan will draw the dust inside
the housing and excessive accumulation
of powdered metal may cause electrical
hazards.
Do not operate the power tool near

flammable materials.
Sparks could ignite these materials.
Do not use accessories that require liquid

coolants.
Using water or other liquid coolants may
result reesult in electrocution or shock.
Kickback and Related Warnings:
Kickback is a sudden reaction to a pinched
or snagged rotating wheel, backing pad,
brush or any other accessory. Pinching or
snagging causes rapid stalling of the
rotating accessory which in turn causes the
uncontrolled power tool to be forced in the
direction opposite of the accessory's
rotation at the point of the binding.
For example, if an abrasive wheel is
snagged or pinched by the workpiece, the
edge of the wheel that is entering into the
pinch point can dig into the surface of the
material causing the wheel to climb out or
kick out. The wheel may either jump toward
or away from the operator, depending on
direction of the wheel's movement at the
point of pinching. Abrasive wheels may also
break under these conditions.
Kickback is the result of power tool misuse
and/or incorrect operating procedures or
conditions and can be avoided by taking
proper precautions as given below.
Maintain a firm grip on the power tool and

position your body and arm to allow you
to resist kickback forces. Always use
auxiliary handle, if provided, for maximum
control over kickback or torque reaction
during start-up.
The operator can control torque reactions
or kickback forces, if proper precautions
are taken.
Never place your hand near the rotating

accessory.
Accessory may kickback over your hand.
Do not position your body in the area

where power tool will move if kickback
occurs.
Kickback propels the electric power tool in
the direction opposite to the movement of
the sanding disc at the point of pinching.
Use special care when working corners,

sharp edges etc. Avoid bouncing and
snagging the accessory.
Corners, sharp edges or bouncing have
a tendency to snag the rotating accessory
and cause loss of control or kickback.
This causes a loss of control or kickback.
Do not attach a saw chain woodcarving

blade or toothed saw blade.
Such blades create frequent kickback and
loss of control.
Special safety instructions for grinding and
cut-off grinding:
Use only those sanding tools authorised

for use with your electric power tool and
the guard designated for this sanding tool.
Sanding tools, which are not designated
for use with the electric power tool, cannot
be adequately shielded and are unsafe.
The guard must be attached securely to

the electric power tool and adjusted to
ensure maximum safety, i.e. the smallest
possible part of the sanding tool is
exposed to the operator.
The guard should protect the operator
from fragments and accidental contact
with the sanding tool.
Sanding tools may be used for the

recommended applications only.
For example: Never grind with the side
area of a cutting-off wheel.
15