Leckey KIT Bedienungsanleitung Seite 47

Leckey Hi Low base options
KIT Hi-low chassis
Top of seat to floor
Min
Max
With handle folded down
Length
Width
Height
LINAK Actuator specification
- 281209-01
Rated IP51
Duty Cycle Max 10% or 2 min continuous use
followed by 18 min not in use.
Ambient temp +5deg to +40deg C
Ambient Operating temp 22deg
Storage temp -40deg C to 70degC
Push Max 3500N
Pull Max 2000N
Self Lock at 3500N Push – 2000N Pull
Typical speed with full load 4.7mm/sec
Max amps at load of 3500N is 3.9 amps
Noise level dB(A) 48
Power input voltage 24v +- 10%
LINAK Battery Box - BA18021-00
Rated IP51
Ambient temp +5deg to 40deg C
Storage temp -20deg C to 60deg C
Rated Capacity 1.2 Ah 24v
Charging current is max 0.3A
Lead acid gel filled battery
mm inches
460 18
640 25
700 27.6
620 24.4
410 16
LINAK Handset - HB41000-00004
Rated IP51
Control current 100mA per channel (Max)
Ambient temp +5deg to +40deg C
LINAK Battery Charger - CH01
Mains 100-240 VAC/50-60 Hz switch mode
power supply
Charging voltage 27.6 VDC +- 2%
Charging current Max 500mA
Green LED for power on
Yellow LED for charging function
Yellow LED turns into green when batteries are
fully charged.
LINAK products may be stored in non-heated
storage facilities with humidity between
0 and 100%, none condensing. None condensing
means that one should not take a product from
an ice cold warehouse into
a room with a temperature of 20deg C;
if this is done then moistness will appear
on the products.