auna DiscoFever Bedienungsanleitung Seite 24

EN
24
Stop
• If the STOP button is pressed in the course of playing, the disc will
cease to play. (The total number of tracks will be shown on the LED
window.)
• Please press STOP before plugging into LINE-IN jack at the back of the
unit. Otherwise the CD mechanism would continue to spinning.
Skip (For both CD and CD+G discs)
In STOP or PLAYBACK mode, you can skip up or down to a specific track by
pressing the forward or back skip button.
Search (For audio CD disc only)
When playing any audio CD, press and hold the SKIP button. The CD will
search at high speed in the forward or backward direction. Normal play will
continue when you release the button.
Repeat (For both CD and CD+G discs)
• During playback, to repeat the track currently playing, press the REPEAT
button once. The REPEAT LED will start to flash.
• To repeat all tracks, press the REPEAT button twice. The REPEAT LED
will light up and stay lit.
• To clear the REPEAT/unction, press the REPEAT button again. The
REPEAT LED will turn off.
Program
Use this button to program and play back songs in a preselected order.
1 Programming should be done in the stop mode only. Press the
PROGRAM button until the PROGRAM LED flashes, the track will show
[00].
2 Press the SKIP buttons to select a desired track.
3 Press PROGRAM button to confirm entry. You can repeat the same steps
upto a maximum of 20 tracks.
4 Press PLAY button when you have completed programming and you are
ready to start singing.
Note: Press the STOP button to clear all the programmed entries.