Wear Parts; Spare Parts - Oase AquaOxy 4800 Gebrauchsanleitung

- EN -
Maintenance and cleaning
Replace air filter
• Remove protective cover (Figure F, 8).
• Remove and replace air filter (9).
• Refit protective cover (8) and let it engage.
Replace membranes
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Never operate the unit with defective membranes. Even when only one membrane is defective, always replace the
complete pair. The procedure is identical (Figure G-J). Please contact your specialist dealer if you do not wish to un-
dertake the replacement yourself.
• Undo screws (10) and remove the upper section of the housing (11) from the bottom section of the housing (12).
• Undo screws (14) on valve unit (15). Lay the screws aside separately from the other screws.
• Tilt valve unit (15) to the side.
• Remove screws (16) including washer (17) from support disk (18).
• Pull off support disk (18) including cover patch (19).
• Remove membrane socket (21).
• Press on membrane (20) to release it out of membrane socket (21).
• Insert new membrane(s).
• Reassemble the unit in the reverse order.
Storage/overwintering
When the unit is in continuous operation it can remain in place at freezing temperatures.) Otherwise store the unit in-
doors in a dry room (room temperature).

Wear parts

• Air filter
• Membrane
• Valve unit

Spare parts

The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
12
www.oase-livingwater.com/spareparts