Sanotechnik CS99 Montageanleitung Seite 45

SLOVENSKO – SLOVENSKO – SLOVENSKO – SLOVENSKO – SLOVENSKO – SLOVENSKO – SLOVENSKO
Bodite pozorni na:
1. Preveriti morate naslednje stvari pri dobavi električne energije:
a. The electrical wire inner wall must exceed 2.5mm
correct and install ground wire and it must be safety.
b. All different wires must match with its fitting parts according to the diagram.
c. Appliance shift of leakage electricity must normally work.
d. The steam pipe must not be blocked or like concave form, otherwise , which will lead to steam exits will usually
spout water or steam generator blows up.
e. Steam generator must be installed on dry and firm metal frame against rainwater. Must not install on the
ground directly.
2. Dnevno bodite pozorni na:
a. Must check an electric leakage rotection switch before using the machine to assure using safety.
c. Method: Put pug into socket and then push RESET, the indicator light will bright, which shows electricity has
been linked. At this time, push TEST and the electricity will be cut off by the electric leakage protection shift,
otherwise ,the switch must be changed new one.
d. Must cut off outside power resource (a long time).
e. Must keep human body away from steam exits during steam bathing to avoid scalding by high degree steam.
3. Posebna navodila
a. Wall power socket must be gb 16 A socket, ensure plug and socket contact and reliable. Otherwise, because
electric current is bedding face hot deformation , damaged leakage protection plugs.
b. The steam generator and the power source of the fuse box indirectly connected terminals, should according to
color a pair Should and should tighten and reliable.
Bodite pozorni na:
1. Pred priklopom izdelka na električno omrežje preverite!
a. Minimalni presek el. vodnika mora biti
varovalko oz. fit stikalom .
b. Vsi vodniki morajo biti vezani po priloženi električni shemi.
c. Izdelek mora biti varovan s pravilno delujočim fit stikalom.
d. V izogib napakam oz. poškodbam parnega generatorja povezovalna cev parnege generatorja ne sme biti zamašena,
prepognjena ali kako drugače poškodovana.
2. Dnevno bodite pozorni na:
a. Preverite pravilno delovanje električnih varoval (varovalka, fit stikalo) po sledeči metodi (b):
f. Priključite izdelek v električno omrežje, pritisnite tipko RESET, ko prične kontrolni indikator utripat prisnite
tipko TEST, fit stikalo se mora izklopit, v nasprotnem primeru preverite pravilno delovanje fit stikala.
g. Ob daljši neuporabi je priporočljivo izključiti izdelek iz
h. V izogib poškodb zaradi visoke temperature pare pri izhodu pare se izogibajte direktnemu stiku telesa z
izhodom pare.
3. Posebna navodila
c. Vtičnica mora biti varovana s 16A varovalko
2
the wire connecting with socket of power source must be
2
2.5mm , vtičnica mora biti ozemljena in ustrezno varovana z lastno
električnega omrežja
45