Specifications - Makita BJS130 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Trigger-lock button
3-2. Switch trigger
4-1. Cutting head
4-2. Screws
4-3. Hex wrench
5-1. Screws
5-2. Side blade L
5-3. Center blade
5-4. Side blade R
5-5. Sleeve
6-1. Cutting head
6-2. Sleeve
6-3. Side blade R
6-4. Center blade

SPECIFICATIONS

Max. cutting capacities
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-5. Side blade L
6-6. Screws
7-1. Cutting head
7-2. Screws
7-3. Hex wrench
7-4. Tighten
8-1. Hex wrench
9-1. Hook
11-1. Side blade
11-2. Side blade surface
11-3. Center blade
11-4. Workpiece
12-1. Screws
12-2. Side blade L
12-3. Center blade
12-4. Side blade R
12-5. Sleeve
13-1. Screws
Model
Steel up to 400 N/mm
Stainless Steel up to 600 N/mm
-1
)
Overall length
Net weight
Rated voltage
) : 74 dB(A)
pA
2
) : 5.5 m/s
h,CM
2
2
2
ENE037-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
13-2. Side blade L
13-3. Center blade
13-4. Side blade R
13-5. Lubricate
14-1. Limit mark
15-1. Holder
15-2. Hex socket head bolt
16-1. Barrel
16-2. Hex socket head bolt
17-1. Front cover
17-2. Screws
18-1. Spring
18-2. Arm
18-3. Recessed part
19-1. Carbon brush cap
20-1. Hole
20-2. Carbon brush cap
BJS130
1.3 mm (18 ga.)
1.0 mm (20 ga.)
2,800
350 mm
2.2 kg
D.C. 18 V
ENG901-1