Koenic KDW 1112 Gebrauchsanweisung Seite 24

Size - A5
English
Legal note:
* EN 50242: This program is the test cycle.
The information for comparability test in
accordance with EN 50242, is as following:
- Capacity: 2 settings
- The power consumption of the:
off-mode is 0.45 W
left-on mode is 0.49 W
Left-on mode duration: Power will be cut
off automatically after program finished for 30
minutes.
Cleaning and care
Warning
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Clean the exterior surfaces of the product
with a slightly damp cloth and dry them
well. Make sure that no water enters the
product interior (e.g. at the display).
• Clean the edge around the door using a
soft, warm and damp cloth only. To avoid
penetration of water into the door lock
and electrical components, do not use a
spray cleaner of any kind.
Cleaning the filter cartridge
The filter prevents larger remnants of food or
other objects from getting inside the pump.
Inspect the filters for blocking every time after
the dishwasher has been used and clean it on a
regular basis.
24
IM_KDW1112_180620_V05_HR.indb 24
The filter system consists of a coarse
Fig.
14
filter, a flat (Main filter) and a micro
filter (fine filter).
• Main filter A: Food and soil particles
trapped by this filter are pulverized
by a special jet on the spray arm and
washed down into the drain.
• Fine filter B: This filter holds soil
and food residue in the sump area
and prevents it from being spread
over the dishes during wash cycle.
Disassemble and clean the filter
according to the following steps:
• Turn the filter cap (filter B)
counterclockwise and take out the
whole filter assembly.
• Take out filters.
• Wash filters under running water.
• Reassembling is done in reverse
order. Make sure the filter cartridge is
installed correctly.
Warning
Do not use the dishwasher without the filter
system being properly installed.
Cleaning the spray arm
The spray arm can be easily removed
Fig.
15
for periodic cleaning of the nozzles.
This prevents possible clogging.
• Grasp the middle of the spray arm,
pull it upwards to remove it.
• Wash the arm under a jet of running
water .
• Return it carefully to its seat and
make sure that the spray arm is
installed correctly and can turn freely.
20/6/18 2:05 pm