Koenic KDW 1112 Gebrauchsanweisung Seite 19

Installation
Note:
The dishwasher is equipped with a power
cord and plug. Make sure that a suitable wall
outlet is available at the desired place.
Place the dishwasher on an even,
Fig.
1
horizontal and steady surface. Consider
the dimensions of the product.
Note:
The dishwasher is not intended to be built in.
Fig. Ensure a leakage-free drain.
2
• Attach the drain hose to the drain
outlet on the back of the appliance.
• Use a screwdriver to properly
tighten the screw of the clamp.
• Place the drain hose in a sink, a floor
drain or similar. If necessary attach
the drain hose with cable ties,
suction cups or similar.
• Ensure that the outlet hose
descents to enable the proper flow
of waste water.
Fig. Connect the water inlet to a tap water
3
supply (3/4") using the provided hose
and make sure it is fastened tightly.
Note:
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is
clear and free of impurities. If this precaution
is not taken, there is a risk that the water
inlet might get blocked and damage the
appliance.
IM_KDW1112_180620_V05_HR.indb 19
If there is no water connection, you can
alternatively fill water by hand into the water
tank opening. The capacity of the integrated
water tank is 5.0 liters. If sufficient water has
been added, a quick beep sounds and the water
connection indicator turns off.
Water must be refilled before each washing
sequence.
Note:
Fill only clear tap water into the water tank
opening. Never fill detergent or similar in the
water tank.
Connect the power plug to the mains.
Fig.
4
Preparation
Putting salt into the salt container
Fig. Depending on your tap water hardness
5
(hardness degree) use additional salt
(water softener). Always consider
instruction provided with the salt.
• Remove the basket and then
unscrew and remove the cap from
the salt container.
• Before first usage, add 1 liter of
water in the salt container of your
machine.
• Place the end of the funnel
(supplied) into the hole and pour in
about 0.13 kg of salt. It is normal
for a small amount of water to come
out of the salt container.
• After filling the container, screw
the cap tightly back on in clockwise
direction.
• Immediately after filling the salt
into the salt container, a washing
program should be started (rapid
program suggested). Otherwise
the filter system, pump or other
important parts of the machine may
be damaged by salty water which
would void the warranty.
English
19
20/6/18 2:05 pm