Koenic KDW 1112 Gebrauchsanweisung Seite 22

Size - A5
English
Operation
Washing dishes
Consider following steps to start the
Fig.
12
washing process:
1. Prepare dishwasher.
2. Load the dishwasher basket.
3. Add detergent or rinse aid.
4. Make sure the water-tap/water supply
is open or the water tank is full, the
appliance is connected to the mains
and the door is closed correctly.
5. Push the on/off switch to turn
on the dishwasher and choose
your program, referring to chapter
Choosing Program.
Note:
Select the extra dry
the dishes to be extra dry.
6. Push Start/Pause button. To stop the
process push the Start/Pause button
again.
To start the rinsing process at a later
time, press the timer
the hours by which the start is to be
delayed by pressing it several times. A
1-24 hours start time delay can be set.
Then press the Start/Pause button.
The dishwasher starts rinsing when
the preset time has elapsed.
7. When the working cycle has finished,
an 8 seconds long beep sounds.
- Turn off the appliance using the
On/off switch and shut off the
water supply.
- Open the door of the dishwasher.
It is dangerous to open the door
when washing, because the hot
water may scald you.
- Wait a few minutes before
unloading the dishwasher to avoid
handling the dishes and utensils
while they are still hot. They will
also dry better.
- Unload the dishwasher.
22
IM_KDW1112_180620_V05_HR.indb 22
function if you want
button. Set
Warning
Modify the washing program
You can modify the washing program when the
dishwasher has just been started. Otherwise,
the detergent may have already been dissolved,
and the appliance may have already drained the
wash water.
• Press Start/Pause button to switch to
standby state.
• Press the Programme selection button P
for more than three seconds. Change the
program to the desired cycle setting.
• Press Start/Pause button again to
continue washing process.
Note:
If you open the door during washing, the
machine will pause. When you close the door,
the machine will continue working after 10
seconds.
Pause the washing process
If you have forgotten some dishes you can
pause a running process and add them, but
make sure the detergent hasn't already
dissolved.
1. Push the Start/Pause button.
2. After the spray arms stop working, you can
open the door completely.
3. Add forgotten dishes.
4. Push the Star/Pause button again to
continue the washing process.
20/6/18 2:05 pm