Sharpening Line Cutter (19); Maintenance Schedule - AL-KO BC 223 L-S Betriebsanleitung

Maintenance and care
3. Check the electrode spacing:
■
Use a feeler gauge (18/5) to check that
the electrode gap (18/6) is 0.6 – 0.7 mm.
If not, carefully tap the electrodes closer
together or carefully bend them apart.
4. If the specified interval is reached or the
spark plug is defective:
■
Replace the spark plug with a new spark
plug. Use the specified spark plug type
(see chapter 13 "Technical data",
page 42).
5. Installing the spark plug:
■
Ensure the spark plug seal ring (18/7) is
on the spark plug.
■
Screw in the spark plug again by hand
and tighten using the spark plug spanner
(torque 12 – 15 Nm).
■
Push on the spark plug connector again
firmly.
Activity
Carburettor
Check idling speed
Air filters
Clean
Renew
Spark plug
Check electrode gap, ad-
just if necessary
Renew
Cooling air inlet
Clean
Silencer
Visual inspection for con-
dition
Fuel tank
Clean
Fuel filter
Renew
469545_d
Once Before
after 5 each
operat- use
ing
hours
X
X
X
8.4

Sharpening line cutter (19)

1. Loosen the mounting screws (19/1).
2. Clamp the line cutter (19/2) in a vice and
sharpen it using a file. File in one direction
only.
3. Attach the line cutter to the guard plate (19/3)
again using the mounting screws. Tighten the
mounting screws firmly.
8.5

Maintenance schedule

The following jobs are allowed to be carried out
by the user independently. All other maintenance,
service and repair work must be carried out in an
authorised service workshop.
NOTE
Shorter maintenance intervals than
those stated in this table may be neces-
sary in case of severe loading and high
temperatures.
Every Every
week 50 op-
erat-
ing
hours
X
X
X
Every If re- Every
100 op- quired year be-
erating fore the
hours mowing
season
X
X X
X X
X
X
39