AKG D 3800M series Bedienungsanleitung Seite 16

2143_03_D3800M_fsch
2 Interfacing
Install the trans-
mitter module:
Fig. 7: Installing the
transmitter module.
Refer to fig. 7.
Replacing the
transmitter
module with the
XLR connector
module:
Fig. 8: Removing
the transmitter
module.
Refer to fig. 8.
16
07.08.2003 11:36 Uhr
3. To avoid losing the fixing screw (1), screw it into the thread-
ed hole (3) in the XLR connector module.
1. Do not forget to check the condition of the battery inside the
transmitter module. If the battery is dead or there is no bat-
tery inside the transmitter module, insert a new battery.
2. Hold the transmitter module (1) to align the contacts (2) with
the microphone.
3. Slide the transmitter module (1) into the microphone body to
the point that the transmitter module (1) will lock with an
audible click.
As the transmitter module locks in place, the electrical con-
nections to the microphone are made automatically.
Note: For details on inserting, replacing, and testing the battery as
well as setting up and operating the transmitter module
refer to the TM 40 transmitter module manual.
1
4
1. Insert a ball point pen, small screwdriver, or similar pointed
object into the opening (1) in the microphone body and
press inward.
Seite 16
2
1
2
3