Installation; Rack Installation - Siemens SISTORE MX Installationshandbuch

Installation

8 Installation
8.1

Rack installation

24
Siemens Building Technologies
Fire Safety & Security Products
To ensure that SISTORE is shut down properly, we recommend to run the unit from a UPS
(uninterruptible power supply). The UPS will also compensate for brief voltage fluctuations.
The 19" standard installation kit for the SISTORE unit is designed for the basic
RITTAL TS8 network cabinet (width: 800 mm, mounting depth: 461 mm) from
RITTAL. In addition to the installation kit, two 19" mounting rails of type DK-TS are
required.
The device must be installed with a minimum clearance of 85 mm on both sides.
CAUTION
Otherwise the device will shut down automatically due to overheating.
1. Remove the housing base on the unit with a screwdriver.
2. Remove the two front cover attachment screws (M4x6) first on one side of the
unit.
3. Screw one of the corner brackets to the side of the unit with the M4x12
screws (see F ig. 10).
7 5 H
Use only the M4X12 screws supplied with the installation kit. Screws that are
CAUTION
too long may cause damage to the device.
4. Remove the two front cover attachment screws on the other side of the unit.
5. Screw on the second corner bracket with the M4x12 screws.
6. Hang the sliding rails in the mounting rails of the network cabinet.
7. Attach the M6 cage nuts for securing the unit in the mounting rails of the
network cabinet.
8. Place the device on the mounting rails and push it into the cabinet.
9. Attach the unit with the four M6x18 screws and plastic washers to the
mounting rails of the network cabinet (see F ig. 10).
7 6 H
02.2009