Connecting Pan-And-Tilt Unit Cdd2410; Connecting Scu Pan-And-Tilt Unit Pt40P Via Controller Cdc050X - Siemens SISTORE MX Installationshandbuch

Installation
8.4.8

Connecting pan-and-tilt unit CDD2410

8.4.9

Connecting SCU pan-and-tilt unit PT40P via controller CDC050x

44
Siemens Building Technologies
Fire Safety & Security Products
Fig. 24 Pan/tilt drive CDD2410 system overview
For a more detailed description of the connections please refer to Section
MX / MX DVD or Section 7 D escription of SISTORE MX 3G / MX 3G DVD.
1 4 9 H 1 5 0 H
1. Connect the pan-and-tilt unit to the SISTORE (see
2. Connect the camera to the SISTORE (see
Further information on this can be found in the instruction manuals for the
pan-and-tilt unit, the converter and the camera.
3. Start the SISTORE MX application software.
4. Switch to configuration mode.
5. Select the Cameras tab.
6. Mark the checkbox PTZ.
7. Choose the camera type from the first list box.
8. Choose the interface from the second list box.
9. Click Apply.
The interface for the camera is enabled.
Further information on this can be found in the SISTORE MX Configuration
Manual.
CDC0501/ CDC0501/
CDC0502 CDC0502
Fig. 25 Controller CDC050x – system overview
For a more detailed description of the connections please refer to Section
MX / MX DVD or Section 7 D escription of SISTORE MX 3G / MX 3G DVD.
1 5 5 H 1 5 6 H
F ig. 24).
1 5 2 H
RS485
SISTORE MX / MX 3G
6 D escription of SISTORE
1 4 7 H 1 4 8 H
F ig. 24).
1 5 1 H
6 D escription of SISTORE
1 5 3 H 1 5 4 H
02.2009